• September 9,2020.

1. Vibration influence Compressed air air compressor or high pressure fan produced.When these devices are running, they all have varying degrees of vibration, and sometimes the vibration is quite stro...

• September 18,2020.

Waist wheel flowmeter, also known as roots flowmeter, is used for continuous or intermittent liquid flow in the pipeline measurement of high precision meter.Its structural features are as follows: the...

• September 24,2020.

1. Vortex flowmeter piping design (straight pipe can be required with the same diameter as the requirement for degree, etc.) There are higher requirements for vortex flowmeter with pipeline installati...

• October 16,2020.

1, there are some impurities in the medium, the bearing, the shaft to wear, so that the gap between the two increase, the dynamic balance of the moving parts is destroyed, rotational speed decline, or...

• December 28,2020.

The porous balance flowmeter is a great improvement on the traditional orifice flow meter and has the remarkable characteristics of balanced rectifier.The traditional throttling device has only one fl...

• January 29,2021.

Vortex flow meter is researched and produced according to Karman vortex flow principle. It is mainly used for flow measurement of industrial pipeline medium fluid, such as gas, liquid, steam and other...

• January 29,2021.

The flow profile of the precession vortex flow sensor is similar to the profile of a Venturi tube (as shown in Fig. 1).A group of spiral guide vanes are placed at the inlet side. When the fluid enters...

• February 26,2021.

Vortex flow meter is a new type of flow meter developed in the seventies. Compared with other forms of flow meters, it has the following advantages: no moving parts inside the meter, simple structure,...

• April 6,2021.

1. What is throttling device?Answer: throttling device is a flow limiting device installed in the circulation pipeline.It comprises a throttle, a pressure taking device and a front and rear straight p...

• July 6,2021.

1. The density compensation when the vortex flowmeter measures the steam should be scientific and accurate. In order to measure the mass flow of steam correctly, the change of steam pressure and tempe...

• July 8,2021.

1. The density compensation when the vortex flowmeter measures the steam should be scientific and accurate. In order to measure the mass flow of steam correctly, the change of steam pressure and tempe...

• August 20,2021.

In recent years, along with the development of electronic technology, digital technology, using the ultrasonic pulse measurement of fluid flow technology develops very fast, based on different princip...